Encore SP201-SA Specifikace stáhnout pdf (Strana 49)

Monitoring and Troubleshooting the SP201-SA Software 7-49

SP201-SA™ Customization and Maintenance Guide

Note: The trace isupmsg command is a constituent part of the former config

traceflags command.

How to Use the trace isupmsg Command

1 To start an ISUP raw message trace, do one of the following at the

user> prompt, where trk represents the trunk number and ts

represents the timeslot (channel) number:

a To start an ISUP raw message trace for a specific timeslot, type

trace isupmsg

trk

on and press Enter.

b To start an ISUP raw message trace for a range of timeslots, type

trace isupmsg

trk1

ts1

trk2

ts2

and press Enter,

where trk1:ts1 represents the range’s beginning trunk and timeslot

and trk2:ts2 represents the ending trunk and timeslot.

c To start an ISUP raw message trace for all timeslots on a single trunk,

type trace isupmsg

trk

on and press Enter.

d To start an ISUP raw message trace for all timeslots on all trunks,

type trace isupmsg all on and press Enter.

 The ISUP raw message trace is started. A message similar to the

following is displayed.

2 To end an ISUP raw message trace, do one of the following at the

user> prompt, where trk represents the trunk number and ts

represents the timeslot (channel) number:

a To stop an ISUP raw message trace for a specific timeslot, type

trace isupmsg

trk

off and press Enter.

Command "trace isupmsg 2:14 7:9 on" completed

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 55 56

Žádné komentáře

Encore SP201-SA Specifikace Strana 49