Encore SP201-SA Uživatelský manuál stáhnout pdf (Strana 5)

SP201-SA™ Installation Guide 5

C Clocking Configuration

(Information on tests and restarts)

(Boot banner and

boot> prompt)

(Do not type

anything. The

application will load

in a few seconds.)

(Initializations)

(Application banner and

user> prompt)

(When you see the user>

prompt, the SP201-SA is

ready for further

configuration.)

What the terminal displays What you type What you are configuring

user> config clocks

Clocking (synchronization)

for the SP201-SA

Enter the trunk number [1-4] from

which this card is to derive its

clock source. Or enter "0" if this

card is to use its internal clock.

The PRIMARY clock source is derived

from (current = INTERNALCLOCK): 1

Clock sourced from the device

connected to the remote end

of the R2 trunk

The SECONDARY clock source is derived

from (current = INTERNALCLOCK): 0

Backup clock sourced from

the SP201-SA

user>

(Clocking has been

configured.)

What the terminal displays What you type What you are configuring

1 2 3 4 5 6 7 8 9 10 ... 13 14

Žádné komentáře

Encore SP201-SA Uživatelský manuál Strana 5